Lancôme Model Prop User Manual
Operating instructions for the Lancôme Genifique prop — includes daily operation, bottle replacement, battery replacement, and other detailed steps.
Product Identification
Daily Operation
| Normal Use In non-triggered state, the side panel whiteLightingcycling: fade-in → fade-out → fade-in continuously. Place your hand under the sensor near the stone countertop. Wait 1 second for a lotion drop. During dispensing, the side panel light stays solid white. After dropping, it returns to breathing gradient. After one drop, wait 5 seconds before triggering again. |
Replacing the Genifique Bottle
| Replacing the Genifique Bottle When the lotion bottle is empty, replace with a new bottle. Steps: A – Remove the logo cap and bottle cap upwards. B – Pull the curved tube out from the empty bottle. C – UnscrewWhite”Customcap”, andscrew it onto the new Genifique bottle. D – Insert the curved tube into the Genifique bottle. The glass tube should rest on the cap edge. E – Return the Genifique bottle to its top position. F – Put the bottle cap back on. G – Place the logo cap on top. Note the logo angle. 3 sets of magnets allow fine angle adjustment. H – Press the manual switch to completely expel air from the tube. I – Clean the dropper opening. If the unit will be unused for an extended period, fill an empty bottle with water and repeat the steps above to flush all lotion from the tubing. Otherwise, dried lotion will clog the tube and render the machine inoperable. |
Replacing the Battery
| Replacing the Battery After a full charge, lasts about 2 days. Actual duration depends on usage frequency. If side panel light is off with no sensor response, battery is depleted. Each unit has 3 batteries. Remove battery and, charge it promptly. Battery replacement steps: A – Press the power switch to turn off the unit. (Popped out = off) B – Remove the logo cap and bottle cap C – Unplug the connector from the device, remove the battery, and replace with a fully charged one. D – Place the charging port plug in the recess. E – Place the logo cap on top. Note the logo angle. 3 sets of magnets allow fine adjustment. F – Press the power switch. G – Charge the depleted battery for backup. The battery voltage is 12V. Only use a 12.6V charger. Do NOT use chargers with other voltages. |
Other Issues
For other issues, contact Dengtec Project Manager Mr. Wang: 139 1377 5186